Deceleration of sliding motorcycles (mainly scooters) in accident reconstructions

This paper presents an analysis of the situation in which a two-wheeler (i.e. a motorcycle, where the term motorcycles includes scooters) falls over to the side and then successively slides; this typically occurs in road accidents involving this type of vehicle. Knowing the deceleration rate of the sliding phase allows the kinetic energy dissipated and the speed of the motorcycle just before the fall to the ground to be calculated. These parameters are very important in the analysis and reconstruction of accidents. The work presented in this paper was developed in two experimental test sessions on fully faired motorcycles which are mainly of the scooter type and widely used in urban areas. In the first session, sliding tests were carried out, with the speed in the range 10–50 km/h, on three different types of road surface. Analysis of the evidence allowed the dissipative main phases of motion of the motorcycle (the impact with the ground, the rebounds and the stabilized swiping) to be identified and some factors affecting the phenomenon to be studied. The coefficient of average deceleration was calculated using two typical equations. The second test session consisted of drag tests. In these tests, the motorcycle, which had previously laid on its side, was dragged for a few metres at a constant speed of about 20 km/h, while the drag force was measured. A comparison of the results obtained in these tests with those obtained in the sliding tests yielded very good agreement in the coefficients of deceleration.