The paper presents mode I and II fracture toughness results for polylactic acid material obtained via fused deposition modeling. The tests were performed using Single Edge Notch Bend specimens loaded in four point bending: symmetric for mode I, asymmetric for mode II, respectively. The notch was inserted by 3D printing, and by milling, respectively. Fracture toughness values measured for the specimens with 3D printed notch resulted to be higher than those obtained by milling. The effect of notch insertion is more evident in mode I while it is less important for mode II.
The effect of crack insertion for FDM printed PLA materials on Mode I and Mode II fracture toughness / Valean C.; Maravina L.; Marghita M.; Linul E.; Razavi J.; Berto F.; Brighenti R.. - 28:(2020), pp. 1134-1139. (Intervento presentato al convegno 1st Virtual European Conference on Fracture, VECF 2020 nel 2020) [10.1016/j.prostr.2020.11.128].
The effect of crack insertion for FDM printed PLA materials on Mode I and Mode II fracture toughness
Brighenti R.
2020
Abstract
The paper presents mode I and II fracture toughness results for polylactic acid material obtained via fused deposition modeling. The tests were performed using Single Edge Notch Bend specimens loaded in four point bending: symmetric for mode I, asymmetric for mode II, respectively. The notch was inserted by 3D printing, and by milling, respectively. Fracture toughness values measured for the specimens with 3D printed notch resulted to be higher than those obtained by milling. The effect of notch insertion is more evident in mode I while it is less important for mode II.File | Dimensione | Formato | |
---|---|---|---|
VECF_2020.pdf
Accesso chiuso
Licenza:
Tutti i diritti riservati
Dimensione
1.74 MB
Formato
Adobe PDF
|
1.74 MB | Adobe PDF | Richiedi una copia |
I documenti in FLORE sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.